Fable: The Lost Chapters Mod Scene: Graphics Editing » What goes into making a mesh 'fable ready'?

Home » Fable TLC » Discussion » Graphics Editing » What goes into making a mesh 'fable ready'?

Show: Today's Messages :: Show Polls :: Message Navigator

Re: What goes into making a mesh 'fable ready'? [message #60080 is a reply to message #60079]

Sat, 06 November 2010 08:23

OldBoy
Messages: 1112
Registered: October 2005
Location: Groningen

Administrator

There's a similar topic going here.
As for what you're working on, weapons are by far the easiest to do, everything else is quite hard.
Also Blenders .x support sucks, so I'd advice you to grab 3dsmax for working on models in .x
You'll need an importer/exporter for it though.

http://img18.imageshack.us/img18/1640/48x48exit.png

this is not an exit.

Report message to a moderator

[Message index]

		What goes into making a mesh 'fable ready'? By: itstwoam on Thu, 04 November 2010 15:07
		Re: What goes into making a mesh 'fable ready'? By: OldBoy on Thu, 04 November 2010 15:37
		Re: What goes into making a mesh 'fable ready'? By: itstwoam on Sat, 06 November 2010 07:30
		Re: What goes into making a mesh 'fable ready'? By: OldBoy on Sat, 06 November 2010 08:23

Previous Topic:	Limit of meshes on models
Next Topic:	importing X files to 3dsmax

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Jan 25 22:25:03 PST 2025

Total time taken to generate the page: 0.04851 seconds