Re: Lotus Staff [message #61004 is a reply to message #61003] |
Thu, 30 December 2010 23:22 |
|
JohnDoe
Messages: 3007 Registered: October 2007
|
Retired
|
|
|
nicomon wrote on Fri, 31 December 2010 00:57 | Are you using the helpers from the hobbe staff, or custom ones? If you're using custom helpers, maybe the helpers from the hobbe staff could help everything get lined up for proper holding.
| Wouldn't matter either way. The only helper specific to the hobbe staff is unused in the definitions and in the effect placement. In fact, I'm not sure any of the helpers are used in effect placement, as I moved around the helpers every which way and got no change of any kind.
I initially rotated the mesh around so that it could look to be held properly, moved the helpers too, mesh was held correctly but the shot still fired from the same place and the effect still appeared in the same place, so while the staff appeared correctly, nothing else did.
[Updated on: Thu, 30 December 2010 23:23] Report message to a moderator
|
|
|